CASE REPORT |
|
Year : 2022 | Volume
: 16
| Issue : 1 | Page : 77-80 |
|
Achieving esthetics with computer-aided design-computer-aided manufacture ceramic veneers
Maninder Hundal, Vaibhav Jain
Indian Naval Dental Centre, Danteshwari, INHS Ashwini, Mumbai, Maharashtra, India
Correspondence Address:
Maninder Hundal Executive Officer and Classified Specialist Prosthodontia, Indian Naval Dental Centre, Colaba, Mumbai India
 Source of Support: None, Conflict of Interest: None
DOI: 10.4103/jodd.jodd_65_20
|
|
Continuous evolution of materials, laboratory techniques, and clinical procedures has made the ceramic laminate veneers a reliable modern technique. Veneers are mainly fabricated from conventional low fusing feldspathic porcelain. Two popular methods for fabrication of porcelain veneers are the platinum foil technique and the refractory die technique. However, these are time-consuming and technique sensitive. In contrast, the computer-aided design/computer-aided manufacture (CAD/CAM) restorations can be made in one visit, and the new equipment and softwares have shown to result in improved marginal fit. This scientific paper focuses on two case reports with different clinical indications restored successfully with two different types of CAD-CAM veneer materials.
|
|
|
|
[FULL TEXT] [PDF]* |
|
 |
|